Grinding –
The best recommendation a carpenter can possess is a good kit of tools, well worn and in fine condition. A chest full of brand-new tools, however nice they may look, is of no use as a recommendation, for it is evident that the man has never used them. When the tools are half worn out, and still are in good condition and ready for instant use, they form pretty good evidence that their owner understands his business.
In looking over a piece of kit possessed by a “wood butcher” not long since, the writer saw an axe which looked like the one shown in Fig 1. There was a big piece broken out of the edge at a, where a spike had evidently come in contact with the edge of the tool. To put this tool in shape considerable grinding must be done.
The first step is to hold the axe against the edge of the grindstone, as shown in Fig 2, until the broken part is entirely removed, leaving the edge at b probably about one-sixteenth of an inch thick. The next step is shown in Fig 3. Rest the head or pole, of the axe, upon the grindstone frame, making a mark at c, so as to be able to replace the axe at will after looking at it. By resting the head of the axe at all times at c, the bevel at d is made flat, and not as shown in Fig. 4. Here there are something more than a dozen different bevels, to say nothing of a corner being ground off where the axe evidently slipped when being placed upon the stone.
(more…)
